[QA] BENTONE® LT additive is an organically modified powdered clay additive designed for water borne systems, primarily latex paints.

ADDITOL XL 109 prevents surface defects in oxidatively drying paints, like icing, wrinkling, shrinkage. Enhances through-drying, levelling and hardness. For paints on oil and alkyd resins. ADDITOL XL 109 is a specific antioxidizing agent for oxidizing paint systems and inhibits or retards the crosslinking reactions initiated by air oxygen in the surface of paint films. Thus ADDITOL XL 109 acts as antiskinning agent and impairs too quick drying of the surface. The paint films remain liquid for longer times and oxygen can contact the deeper layers of the films. Through drying is enhanced and becomes uniform over the whole layer of the film.Surface defects usually due to inuniform drying, like icing, wrinkling and shrinkage can be prevented. At the same time, gloss, levelling, and film hardness are enhanced.ADDITOL XL 109 remains active in the paint on prolonged storage in closed containers. Crystallization eventually occurring on storage at lower temperatures can be dissolved by gentle heating. We recommend to jointly use ADDITOL XL 109 and ADDITOL XL 297. Both additives are supplementary in effect giving superior performance in respect of antiskinning, drying and gloss.

ADDITOL VXW 4926 is a rapid defoaming or air release.It allows high film thickness of stoving paints, without cissing. Also suited for combinations of dispersions with water dilutable synthetic resins.ADDITOL VXW 4926 is a surface active additive for water dilutable paints. Particularly with spray application cissing on curing of the paint is prevented or may appear only with higher film thickness. Since ADDITOL VXW 4926 is not dilutable with water, it should be incorporated with great care. The dosed range is between 2 % and 15 % for 100 % binder solids. The optimum quantity should be determined in individual tests.

ADDITOL VXL 4950 is a product without special pre-treatment of plastic materials such as polyethylene, polypropylene and polyamide (e.g. corona discharge, roughening, flame or chromic acid treatment) good adhesion of coatings can be obtained after applying a thin adhesion promoting layer of ADDITOL VXL 4950 to the surfaces. For plastic substrates made of polyethylene a short period of additional UV-irradiation of this film is recommendable. In general irradiation of ADDITOL VXL 4950-coatings can further improve adhesion .