ROSKYDAL K 65 is a binder for highly filled, coarse and fine knifing fillers for use on metal, wood and mineral substrates. Fillers based on ROSKYDAL K 65 cure fully when applied in both thin and thick coats. They can be made harder by the addition of, for example, ROSKYDAL K 14 M or ROSKYDAL K 36. Formulation Combinations of talc, dolomite/calcite and baryteswith lowiron content have proved suitable as extenders, with talc as the main component because it improves the adhesion to the substrate.

BECKOPOX EP 386W/52WA is an internally plasticized solid resin-Type 1-dispersion with improved shear stability, e. g. for water reducible fast drying anticorrosion primers and coatings for plastics. BECKOPOX EP 386W/52WA is an internally plasticized type 1solid epoxy resin as aqueous dispersion. Formulated together with adequate curing agents such as e. g. Beckopox EH 613w or VEH 2188w it is suited for corrosion protection primers with very good adhesion to most metallic substrates. It is also suitable for use in single coat and decorative systems for metallic substrates. For optimium corrosion protection it is recommended using 80 % of the stoichiometric curing agent not contain functional groups capable of reacting with epoxy groups.

DAOTAN VTW 1686/40WA is used as sole binder or in combination with melamine resins and/or polyurethane dispersions for the production of waterdilutable industrial paints, e. g. base coats.

BECKOPOX EH 623W/80WA is a hardener for water-reducible coatings on mineral and metallic substrates, hydryaulic epoxy mortars (ECC). BECKOPOX EH 623W/80WA is used in combination with the water emulsifiable liquid resins Beckopox EP 122w, EP 147w and other liquid resins such as Beckopox EP 140, EP 116 and the solid resin dispersions Beckopox EP 384w and EP 385w (preferably in combination with liquid EP-resins) to produce water-thinnable paints hardening at room temperature with good adhesion to all mineral substrates.Drying at elevated temperatures (> 60 °C) should be avoided. At such conditions traces of acrylonitrile will be released. If the hardener is diluted with water there may be stability problems at solid concentrations of less than 20 %, especially at storage temperatures above 35 °C. When pigments and fillers are being dispersed in the hardener, the temperature must not be allowed to rise above 40 °C. These paints retain a constant gloss irrespective of thinning ratio or the time between mixing and the end of the pot life. Beckopox EH 623w may be used in combination with Beckopox EP 128 as an additive for hydraulic mortars, the mechanical properties of the cured system being considerably enhanced by the additive.