ADDITOL VXW 4926 is a rapid defoaming or air release.It allows high film thickness of stoving paints, without cissing. Also suited for combinations of dispersions with water dilutable synthetic resins.ADDITOL VXW 4926 is a surface active additive for water dilutable paints. Particularly with spray application cissing on curing of the paint is prevented or may appear only with higher film thickness. Since ADDITOL VXW 4926 is not dilutable with water, it should be incorporated with great care. The dosed range is between 2 % and 15 % for 100 % binder solids. The optimum quantity should be determined in individual tests.

ADDITOL VXW 6386 Easy emulsifable defoamer, espacially for high quality waterborne sytems, at there conventionally mineral-oil or silicon based defoamers cause decrease the surface quallity of the film (orange peel, craters). At forced and stoving drying paints it can observed a higher cissing free filmthickness. ADDITOL VXW 6386 is qualified for following waterborne systems: stoving enamel based on alkyd- or acrylic-melamine resin, 2 component acrylic-isocyanate paints, paints based on waterdilutable alkyd resin and gloss and semigloss dispersion paint.

ADDITOL VXW 4973 is an easily emulsifiable defoamer with very good incorporating ability. It is suited for defoaming of coarse-disperse to fine-disperse (plastic) dispersions on the basis of PVAC, PVC, acrylates and their copolymerisates. Also low-viscous products may be defoamed with ADDITOL VXW 4973.

MODAFLOW LAMBDA is a unique acryl-silicone polymer hybrid technology flow promoter combining individual efficiencies from high end acrylic as well as silicone leveling performance. It is highly compatible in all non-aqueous clear coat and topcoat formulations and outperforms surface characteristics such as: gloss, DOI, sharpness & brilliancy, anti orange-peel effect. It is efficient at low dosage levels and incorporates easily in many solvent borne resin types including high solids and ultra-high solids. Further it can be applied in solvent free and radiation curing systems.MODAFLOW LAMBDA demonstrates superior balance of compatibility and effectiveness compared to traditional silicone or acrylic flow and leveling additives in Automotive OEM, refinish as well as industrial coatings. Due to its high hydroxyl functionality, MODAFLOW LAMBDA may be co cross-linked in stoving or 2K systems and does not show a decrease in interlayer adhesion. In multiple layer systems the stoving temperature should not exceed 130 °C to ensure a good recoatability. The recommended dosage level is 0.05 % calculated on total formulated coatings as a starting point and optimum dosage range is between 0.05 % - 0.3 %. In some cases the dosage could be increased up to 0,5 %.