Sơn & Sơn phủ

ADDITOL VXW 4973 is an easily emulsifiable defoamer with very good incorporating ability. It is suited for defoaming of coarse-disperse to fine-disperse (plastic) dispersions on the basis of PVAC, PVC, acrylates and their copolymerisates. Also low-viscous products may be defoamed with ADDITOL VXW 4973.

PC-1644 DEFOAMER is a 40 % solution of an acrylic polymer in a petroleum solvent. It was developed to offer improved defoaming performance versus PC-1244 in non-aqueous organic fluids. PC-1644 is a general purpose defoamer which offers superior foam control at low use levels, generally 10 to 20 % lower use level versus PC-1244. PC-1644 is silicone-free and exhibits very low odor. PC-1644 defoamer applications include usage in gear oils, specialty lubricants, and shock absorber, hydraulic, turbine or transmission oils. Typical use levels of the solutions range from 50 - 500 ppm (20 - 200 ppm active polymer). The optimum level is dependent upon the nature of the oil and it is therefore necessary to run a concentration profile for each oil. The defoamer is most typically employed at 200 - 250 ppm of solution (80 - 100 ppm active polymer).

MODAFLOW AQ 3025 is an acrylic flow additive for aqueous coatings. It has been developed for use in water-reducible, latex, and dispersion systems and is compatible with a broad range of chemistries. Modaflow AQ 3025 is amine neutralized in water and contains no organic solvents or silicone. The low viscosity of Modaflow allows for easy incorporation into the coating formulation versus Modaflow AQ 3000.

MODAFLOW RESIN is a flow modifier for non-aqueous industrial coatings and powder coatings. Using of Modaflow Resin in non-aqueous industrial coatings can significantly improve the properties of unmodified resins as follows: Improve flow and leveling, Reduce pinholes, fisheyes, craters and orange peel, Improve substrate wetting, Maintain or improve substrate adhesion, Defoam and aid in air release and Facilitate pigment dispersion. Modaflow resin is also effective in eliminating pinholes and craters in epoxy, polyester, hybrid, urethane, and acrylic powder coatings. Modaflow resin does not contain silicone ingredients. Modaflow Resin is regulated by the U.S. Food and Drug Administration (FDA) for indirect food contact applications under several parts of Title 21, Code of Federal Regulations. Details on specific coverage are available upon request. Quantity to be added: 0,1 - 2,0 % on solid resin