MODAFLOW 9200 is a new low‐viscosity flow modifier developed for high performance in solvent‐based automotive and industrial coatings, especially in clear top coat applications where it offers high gloss, low orange peel, and excellent DOI (Distinctivness of Image) in the coating film. Using of Modaflow 9200 can significantly improve the quality of the coatings as follows: improves flow and leveling, reduces pinholes, fisheyes, craters and orange peel, improves substrate wetting, improves or maintain high gloss, improves or maintain substrate and intercoat adhesion, facilitates pigment dispersion, quantity to be added: 0.1 ‐ 2.0 % on solid resin.

MODAFLOW Powder III resin modifier is an efficient flow aid for industrial powder coatings. Very fine, free flowing particles make MODAFLOW® Powder III easy to incorporate into epoxy, polyester, hybrid, urethane or acrylic powder formulations. Like other members of this family, MODAFLOW® Powder III offers users: Improved flow and leveling, Reduced pinholes, fisheyes, craters, and orange peel, Improved substrate wetting and Enhanced initial adhesion. MODAFLOW Powder III is composed of materials regulated by the U.S. Food and Drug Administration (FDA) for indirect food contact applications under several parts of Title 21, Code of Federal Regulations. Details on specific coverage are available upon request. MODAFLOW® Powder III contains no silicone. Optimum concentrations for a specific formulation should be determined by incremental addition. In general, MODAFLOW® Powder III use levels vary between 0.5 - 2.0 parts per hundred resin.

MODAFLOW 2100 is a flow modifier developed for high performance polyester and acrylic based, high solids and UV liquid coating applications. Modaflow 2100 contains no silicone ingredients. The addition of Modaflow 2100 will help: improve flow and levelling, reduce pinholes, fisheyes, craters, and orange peel, improve substrate wetting, aid in air release, facilitate pigment dispersion, quantity to be added: 0.1 - 1.0 % on solid resin.

PC-1644 DEFOAMER is a 40 % solution of an acrylic polymer in a petroleum solvent. It was developed to offer improved defoaming performance versus PC-1244 in non-aqueous organic fluids. PC-1644 is a general purpose defoamer which offers superior foam control at low use levels, generally 10 to 20 % lower use level versus PC-1244. PC-1644 is silicone-free and exhibits very low odor. PC-1644 defoamer applications include usage in gear oils, specialty lubricants, and shock absorber, hydraulic, turbine or transmission oils. Typical use levels of the solutions range from 50 - 500 ppm (20 - 200 ppm active polymer). The optimum level is dependent upon the nature of the oil and it is therefore necessary to run a concentration profile for each oil. The defoamer is most typically employed at 200 - 250 ppm of solution (80 - 100 ppm active polymer).