Peintures et revêtements

ROSKYDAL K 65 is a binder for highly filled, coarse and fine knifing fillers for use on metal, wood and mineral substrates. Fillers based on ROSKYDAL K 65 cure fully when applied in both thin and thick coats. They can be made harder by the addition of, for example, ROSKYDAL K 14 M or ROSKYDAL K 36. Formulation Combinations of talc, dolomite/calcite and baryteswith lowiron content have proved suitable as extenders, with talc as the main component because it improves the adhesion to the substrate.

ROSKYDAL XP 2072 is especially suitable for conventional- or UV-curing (transparent or pigmented) topcoats and pigmented sealers for wood and furniture. properties for applications by spraying or curtain in UV- or conventionalcuringsystems. ROSKYDAL XP 2072 is usually used as the sole binder. If made necessary by the application (high amount) and compatibility exists, it can be flexibilized with other ROSKYDAL grades, e.g. ROSKYDAL 550 or E 70.

SETATHANE D 1155 is applied in combination with e.g. SETATHANE D 1145 and 1150 in the formulation of coatings SETATHANE D 1155 is not recommended as a sole binder. Because of its low viscosity, SETATHANE D 1155 is especially suitable for combination with SETATHANE D 1145 and 1150 in the formulation of solventfree, self-leveling polyurethane coatings of low viscosity. Desmodur® VL or VL 50 are normally used as hardener.

SETATHANE D 1145 is applied in the formulation of hard and tough coatings and synthetic resin mortars.It is used in combination with other polyols such as SETATHANE D 1150 and crosslinked with Desmodur VL, SETATHANE D 1145 is suitable for use in the formulation of two-component coatings. The main applications are in the construction industry. Curing yields hard to tough but flexible films which are resistant to abrasion and chemicals. In combination with other polyols such as SETATHANE D 1150 and crosslinked with Desmodur VL, SETATHANE D 1145 is suitable for use in the formulation of two-component coatings. The main applications are in the construction industry. Curing yields hard to tough but flexible films which are resistant to abrasion and chemicals.